Provision a BGP Peer

You can configure a BGP peer.

About this task

Complete the following tasks to configure a BGP peer in your XCO fabric:

Procedure

  1. Create BGP Static Peer
  2. Create BGP Dynamic Peer
  3. Getting the Operational State of the BGP Peers
  4. Configure Route Map Attribute
  5. Configure remove-private-as on BGP Peer
  6. Configure default-originate to Advertise Default Route on BGP Peer
  7. Configure Backup Routing Neighbors on BGP Peer
  8. Configure Send-Community on Tenant BGP Peer
  9. Configure Out-of-band for a Tenant BGP Peer or Peer Group
  10. Configure Multi Protocol BGP on Tenant Dynamic BGP Peer
  11. Configure Multi Protocol BGP on Tenant Static BGP Peer
  12. Enable or Disable MP BGP Capability for IPv6 Prefix Exchange over IPv4 Peer
9038968-00 Rev AB